![]() TURN OFF WATER - Next, turn off the water supply to your toilet.This shows the water level of your tank so you can match it once you’ve replaced the part. REMOVE LID AND MARK WATER LEVEL - Remove the lid from the toilet tank, then take a pencil and mark the level of the existing water line.Below you’ll find the steps written out as well. Here is a video explaining how to replace a toilet fill valve. Other supplies you will need include a small bucket, a sponge, a pair of pliers, a pencil, a screwdriver, a tape measure and possibly a utility knife. Check this first and pick up a flexible supply line so you have one on hand to make this repair. You may also need a new supply line (the tubing that runs from beneath your tank to your water supply) if yours is a solid, inflexible line. This will generally run you anywhere from $10-$20. Pick up a new fill valve at your local hardware store, making sure it’s the correct fit for your toilet. Fortunately, it’s a relatively easy fix that can be done with minimal expense and a few basic tools and supplies. If you look inside the tank of your toilet and see that the fill valve is leaking or spraying water from either the top, or leaking water from the bottom of the tank, chances are good it needs to be replaced before it wastes you any more water or causes any damage to your home. Sometimes, a running toilet is caused by a bad fill valve that needs to be replaced. TURN WATER BACK ON & TEST - Turn the water back on to fill the tank and flush the tank to see how it all works.You don't want to have too much play in the chain, because when the flapper closes, it could get caught between the flapper and the flush valve, causing it to not seal correctly. If you find you have excess chain, you will want to adjust the length. ATTACH & ADJUST FLAPPER CHAIN - Connect the chain to the chain arm.CONNECT NEW FLAPPER - Hook the new flapper to the base of the flush valve with the two tabs.It's good practice to clean the rim of the opening as well, using a sponge or a paper towel. You don't want any mineral deposits or hard water buildup to cause the flapper to not seal well. CHECK & CLEAN FLUSH VALVE - Run your fingers along the inside and the top of the valve to make sure it's smooth.Be aware that over time, the flapper starts to deteriorate and can leave a black, sooty residue on your hands when changing it. Unhook the tabs and completely remove the old flapper. REMOVE THE OLD FLAPPER - The flapper should still be connected to the flush valve at the base by two tabs.REMOVE CHAIN FROM FLUSH ARM - Free the flapper by disconnecting the chain from the flush arm.Hold the handle down so all of the water drains out of the tank. FLUSH TOILET TO DRAIN TANK - Next, flush the toilet to empty the water out of the tank.Once the water is off, remove the lid from the toilet tank. SHUT OFF WATER & REMOVE LID - The first step is to shut off the water by turning the water valve below the toilet.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |